您好,欢迎进入深圳市羽杰科技有限公司官网!
183-0000-2010

联系我们

深圳市羽杰科技有限公司
联系人:王生
电话:183-0000-2010
地址:深圳市龙岗区平湖华南城M20栋 在线咨询

切削液泡沫多怎么办,切削液泡沫如何修复

发布日期:2019-10-11 浏览次数:12

如何修复泡沫多的切削液

How to repair foam cutting fluid

u=1743435952,1361534611&fm=26&gp=0.jpg

情况:冷却液从主轴排出后立即发生机器发泡并冲洗干净。

Situation: Machine foaming occurs immediately after the cooling fluid is discharged from the spindle and is washed clean.

1.用折光仪检查浓度。

1. Check the concentration with refractometer.

2.从主轴上取下冷却液样品并摇匀; 泡沫应该在8秒以内破裂。

2. remove the coolant sample from the spindle and shake it well; the foam should burst within 8 seconds.

3.用夸脱瓶中的一滴消泡剂处理保留样品; 泡沫应该在5-8秒内破裂。

3. use a drop of defoamer in quart bottle to retain the sample; the foam should burst within 5-8 seconds.

4.卸下,检查并清洁所有过滤器。它们可能已经从油或运输保护成分中堵塞; 或者已经收集了足够的碎屑以充当屏障并导致泡沫剥离。

4. Unload, check and clean all filters. They may have been blocked from oil or transport protection, or enough debris has been collected to act as a barrier and cause foam stripping.

5.打开冲洗液,将夸脱瓶分散在机器中,或在主轴上进行; 分散很慢。

5. Open the flushing fluid and disperse the quart bottle in the machine or on the spindle; the dispersion is very slow.

6.从主轴上取下保留样品; 观察泡沫在5秒内破裂。

6. remove the retained sample from the spindle and observe that the bubble will burst within 5 seconds.

7.在机器中加入水或冷却液,使冷却液达到10%。

7. Add water or coolant to the machine to make the coolant reach 10%

本文标题:切削液泡沫多怎么办,切削液泡沫如何修复 原文链接地址:http://www.fangxiuoil.com/show.asp?id=35

你觉得这篇文章怎么样?

0 0
标签:全部
网友评论

管理员

该内容暂无评论

中国网友
183-0000-2010